Звуковая система Шкода Карок

admin

Administrator
Автомобиль
VW Tiguan 2.0 TDI DBGC 2018
Sound system Skoda Karoq
Overview of locations where sound system is fitted


Overview of locations where sound system is fitted Skoda Karoq


1 - Front treble speaker
2 - Central speaker
3 - Rear treble speaker
4 - Subwoofer
5 - Rear bass speaker
6 - Digital sound package control unit - J525
7 - Front bass speaker

Removing and installing digital sound package control unit/amplifier
Removing
– Switch off all electrical components and take out the ignition key.
– Push the left front seat completely towards the rear and the highest point.

Звуковая система Шкода Карок


– Remove expanding rivets (2) and remove cover (1) towards the front.

Звуковая система Шкода Карок


– Remove screws (2).
– Gently swivel out the control unit (1) and pull it out of the holder (3).
– Slacken by tilting out the clamp and disconnect the plug connection.

Звуковая система Шкода Карок


– Release and disconnect the “MOST bus” databus (2).
– Protect socket for MOST-Bus Databus (2) with cover (1). You can also use another suitable way (e.g. wrap around a clean film and tape up).
Installing
Installation is performed in the reverse order, pay attention to the following points:
– When replacing, code the new control unit with the Vehicle diagnostic tester.
– If the MOST-Bus data bus is damaged, replace databus with end pieces

Specified torques
ComponentNm
Screw of the control unit1.5 Nm

Removing and installing the rear treble speaker -R14- / -R16-
Removing
– Remove rear door trim
Carefully drill out the heads of the plastic rivets (1) with a suitable drill and remove the speaker (2).

Звуковая система Шкода Карок


– Remove remains of the plastic rivets (cut off, grind down).
Installing
Installation is performed in the reverse order, pay attention to the following points:
– Secure new speaker (2) with screws (3)

Specified torques
ComponentNm
Fixing screws for speakers0.5 Nm

Remove and install front tweeters - R20- / -R22-
Front tweeter is integrated into the A-pillar trim at the top. Replace the AS column cover if damaged

Removing and installing the rear bass loudspeaker -R15- / -R17-
Removing
– Switch off the ignition and all electrical components.
– Remove the door trim panel from which you are removing the speaker
– Disconnect socket connector at the loudspeaker.
– Drill out the rivets (1) with a suitable drill and remove the speaker (2).

Звуковая система Шкода Карок


Caution
- It is important to remove all the drill swarf from the door since it can otherwise lead to corrosion.
- Any damage to the paintwork which is caused by drilling out the rivets must be repaired immediately by a specialist.
Installing
Installation is carried out in the reverse order.

Removing and installing the front woofers -R21- / -R23-
Removing
– Switch off the ignition and all electrical components.
– Remove the door trim panel from which you are removing the speaker
– Disconnect socket connector at the loudspeaker.
– Drill out the rivets (1) with a suitable drill and remove the speaker (2).

Звуковая система Шкода Карок


Caution
- It is important to remove all the drill swarf from the door since it can otherwise lead to corrosion.
- Any damage to the paintwork which is caused by drilling out the rivets must be repaired immediately by a specialist.
Installing
Installation is carried out in the reverse order.

Removing and installing subwoofer - R211-
The subwoofer - R211 is located in the recess for the spare wheel.
Removing
– Switch off the ignition and all electrical components.
– Raise and lock luggage compartment floor
– Unlock the plug connection (2) and disconnect.

Звуковая система Шкода Карок


– Unscrew securing nut (3) and remove subwoofer (1).
Installing
Installation is carried out in the reverse order.

Specified torques
ComponentNm
Screw of the subwoofer3 Nm
Nut of the subwoofer3 Nm

Removing and installing the central speaker
Special tools and workshop equipment required
Disassembly wedge - 3409-
Only on vehicles with the equipment “Soundsystem”
Removing
Caution
When using the lever tool, mask points where the lever tool is applied using commercially available adhesive tape.
– Switch off the ignition and all electrical components.
– Unclip cover (1) with the disassembly wedge and remove from the dash panel (arrows).

Звуковая система Шкода Карок


– Unscrew screws (1) and remove speaker (2).

Звуковая система Шкода Карок


– Disconnect plug.
Installing
Installation is performed in the reverse order, pay attention to the following points:

Specified torques
ComponentNm
Screws of the speaker1 Nm
 
Верх